BSI Insta-Cure+™ is a higher viscosity CA for loose-fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close-fitting joints such as laminations, INSTA-CURE+ ™ should also be used. To prevent premature curing, don’t spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out.
Works Best On:
- Balsa Wood
- Soft Wood
Works Good On:
- Hard Wood
- Glass & Metal
- Fiberglass
- Ceramics
- Hard Plastics
- Rubber
- Laminating
- Water-Resistant
- Reinforcing
Size: 2 oz. (56.8 g)
Directions
Unscrew the top from the nozzle. For finer applications, use the extender tip. Apply Insta-Cure+™ CA to one side of the parts being joined, then hold them tightly together for 5-15 seconds. For larger bonding areas, apply serpentine beads of the CA with enough spacing to allow for the spreading of the adhesive. Insta-Set™ accelerator can be sprayed to cure the CA that oozes from joints. Full strength is reached in three hours. Wipe the nozzle clean before replacing the screw-on top. Refrigerate to extend shelf life. Cured CA is stable from -40 to 220° F. Soak the extender tip in acetone for cleaning.
Special Orders
Please Note: that Special Order items can take longer than the estimated arrival time. The estimated arrival time is based on the last person who ordered the item. However it is ultimately dependant on the manufacturers lead times. Special orders can not be refunded as they are made to order. If you are looking for a specific product there may be alternate ways such as a colour change that speeds up this timeline. It is best to call or email us if your on a time crunch, or wait patiently. Thank You!