UN-CURE™ debonder will soften cured bSi Bob Smith Maxi-Cure. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the glue in about a minute. Apply on bonded skin and roll apart fingers. Once un stuck, use acetone to clean off softened Maxi-Cure glue, then wash off with soap and water. Since cured the maxi cure super glue is essentially acrylic plastic, anything that will dissolve the glue will also soften most plastics. Therefore, care must be used, when using Un-Cure on plastics.
Un-Cure™ will soften cured super glue (aka cyanoacrylate, CA). To release bonded skin (not near the eyes) apply Un-Cure™, then use a small, rounded object like a paperclip to separate the skin with a peeling action, applying more Un-Cure™ as needed until the skin areas are debonded. Wash the area with soap and water. The natural shedding of the skin’s outer layer will remove any residual CA within 12 hr. For removing CA from hard surfaces, soak a cloth or paper towel in Un-Cure™ and rub areas vigorously. Un-Cure™, however, will mar most plastics.
Available in 28ml (1oz)
